Halloween Jack-O’-Lantern Scene DTF Apparel Transfer — Series 26

Bring a little Halloween glow to your next creation. A bold jack-o’-lantern anchors this detailed scene of smaller pumpkins, candlelight, flying bats and autumn leaves, with orange and gold artwork against deep purple accents.

Choose your finish

• Transfer Only — $8.95: one ready-to-press apparel DTF transfer; you supply the blank and apply the design.
• Transfer + T-Shirt (DIY) — $17.95: the transfer and a blank Gildan Softstyle 64000 T-shirt; you apply the design.
• Finished T-Shirt — $23.95: Fashion Honey’s applies the design to the selected shirt. Includes the $6 pressing service; allow 2–5 business days for preparation.

Planned adult/unisex shirt choices: M, L, XL and 2XL in Black, Sand, Natural, Sport Grey, Charcoal or Sage. Blanks will initially be ordered as needed, with selected sizes and colors kept in stock later. Supplier availability and fit will be confirmed before this draft is activated. Planned placement for finished shirts: Front or Back, one placement per transfer. Hoodie, crewneck sweatshirt and tote options are being planned; their blank prices and availability are not yet finalized.

Transfer size

11 inches wide. Height is pending confirmation. Check the full transfer dimensions and the usable print area of your blank before application.

Artwork placement

For finished apparel, choose Front or Back; one placement is included per transfer. Placement measurements run straight down the garment centerline from the bottom edge of the collar ribbing (where it meets the garment body) to the top of the printed artwork, excluding clear carrier-film margins.

• Adult crewneck T-shirts, M–L: planned front placement approximately 3 inches below the front collar; planned back placement approximately 3 inches below the back collar.
• Adult crewneck T-shirts, XL–2XL: planned front placement approximately 3–3.5 inches below the front collar; planned back placement approximately 3 inches below the back collar.
• Future crewneck sweatshirts: front placement approximately 3–3.5 inches below the neckline; back placement assessed on the selected blank.
• Future pullover hoodies: front placement approximately 3–3.5 inches below the neckline, within the space above the pouch pocket. Back placement is measured separately on each hoodie to account for the resting hood; the actual distance will be confirmed before pressing.

These are Fashion Honey’s proposed placement targets, not fixed manufacturer specifications for each size. Final placement may shift slightly for garment fit, neckline, artwork proportions and seams. The confirmed 11-inch artwork width stays the same across sizes; transfer height and fit on the selected blank must be checked before pressing.

Pressing instructions — cold peel

1. Pre-press the blank for 3–5 seconds to remove moisture and smooth wrinkles.
2. Place the adhesive/printed side against the fabric, carrier film facing up. Align the design.
3. Press at 300°F for 12–15 seconds with heavy, even pressure. Keep the garment and transfer flat.
4. Allow to cool completely, then carefully peel the carrier. Do not force lifting artwork.
5. Cover with parchment or a Teflon sheet and press again for 5 seconds.

These settings are a starting point. Presses and fabrics vary, and some transfers need more time. Follow the instructions supplied with your transfer and check adhesion. The personalized pink guide is included in this listing’s images.

Care

Store the unapplied transfer flat in a cool, dry place. After application, wait 24 hours before washing; wash inside out in cold water, avoid bleach, tumble dry low or hang dry, and do not iron directly on the design.